Fluid Mechanics Training

Thursday, November 20, 2008

..:: Training ::..

Training

Training is an ongoing activity at Fluid Mechanics, Inc. We are continually training our technicians or those of our customers to properly rebuild the products we represent. We conduct training at either Cleveland, Ohio

or Fort Lauderdale, Fl

We can conduct training at the customer site. In all cases the training is focused on a paticular fuel pump and injector and tailored to meet the needs of the customers technicians. Included in the training at Fort Lauderdale or Cleveland is calibration of the fuel injection pump.

Classroom Training.JPG

Instructors are from Fluid Mechanics, Inc. and are often accompanied by Factory personnel. This is a typical classroom setting and active class participation is encouraged.

On Hands Training.jpg

Classroom training is put to use in the on-hands portion of the training class.

We try and limit class size to ten (10) or fifteen (15) technicians and a fifty-fifty (50/50) classroom to on-hands training split.

Medium Speed Test Stand.jpg

See the fuel injection pump calibrated to factory specifications.

Inj Pop tester.jpg

Set injector "pop off" pressure and test for atomization, leak down, drips and check spray angle

Created and Maintained by WSI | Terms Of Use | Privacy Statement

4521 West 160th Street Cleveland, Ohio 44135 (216) 362-7800 | 215 S.W. 32nd Street Ft. Lauderdale, Florida 33315 (954) 525-1755